Message type: E = Error
Message class: SB - Version Management Messages
Message number: 302
Message text: Request &1 not found in SAP system &2
According to the administration data in the CS* System, change request
&V1& from system &V2& is a part of the corrective action you are
currently implementing. This request was not found when the request
data was read from the system &V2&.
There is an (at least temporary) inconsistency in the data.
The system issues an error message and will not allow you to continue with this transaction until the error is resolved.
You can continue as normal. However, you cannot access data in the
request &V1&. (If the error message still appears when you call
transaction SCWB again, notify the system administration.)
Error message extract from SAP system. Copyright SAP SE.
SB301 Request &1 not found in SAP system &2 (destination &3)
What causes this issue? According to the administration data in the CS* System,...
SB300 Error in remote connection to SAP system &1 (destination &2): &3&4
What causes this issue? An error occurred during RFC communication with the SAP...
SB303 Position the cursor on a request or task
What causes this issue? You chose <LS>Copy changes</>. However, the...
SB304 No RFC destination found for system &
Self-Explanatory Message Since SAP believes that this specific error message is ...
SAP messages fall into 3 different categories: Error messages
(message type = E), Warnings (W) or Informational (I) messages.
An error message will prevent you from continuing your work - it is a hard stop and you need to fix the error before you can proceed. A warning message will stop your work, however, you can then bypass the warning by pressing the Enter key on your keyboard. That said, it is still good practice to investigate the cause of the warning message and address it. An information message will not stop your work and is truly just for informational purposes.
Click on this link to search all SAP messages.