1. SAP Error Message ›
  2. Message Class S1 ›
  3. S1856


S1856 - Operator & was specified, but the values are in increasing sequence

Start a new search

SAP Error Message - Details

  • Message type: E = Error

  • Message class: S1 - Statistik / SAP-Monitor

  • Message number: 856

  • Message text: Operator & was specified, but the values are in increasing sequence

  • Show details Hide details

  • What causes this issue?

    One of the operators '>, >=' was used, but you have specified the
    values
    in increasing sequence.

    System Response

    This may lead to a misinterpretation of the parameter.

    How to fix this error?

    If you are using one of the operators named above, specify the
    parameter values in decreasing sequence.
    'Green' should have the largest value.

    Error message extract from SAP system. Copyright SAP SE.


AnswerBot

  • What is the cause and solution for SAP error message S1856 - Operator & was specified, but the values are in increasing sequence ?




  • AnswerBot is an artificial intelligence solution provided by tomco.ai.
    Disclaimer

Related SAP Error Messages

Click the links below to see the following related messages:


SAP messages fall into 3 different categories: Error messages (message type = E), Warnings (W) or Informational (I) messages.

An error message will prevent you from continuing your work - it is a hard stop and you need to fix the error before you can proceed. A warning message will stop your work, however, you can then bypass the warning by pressing the Enter key on your keyboard. That said, it is still good practice to investigate the cause of the warning message and address it. An information message will not stop your work and is truly just for informational purposes.

Click on this link to search all SAP messages.