/CWM/MD023 - First reset the category of the parallel unit of measure &1

SAP Error Message - Details

• Message type: E = Error

• Message class: /CWM/MD -

• Message number: 023

• Message text: First reset the category of the parallel unit of measure &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

AnswerBot

• What is the cause and solution for SAP error message /CWM/MD023 - First reset the category of the parallel unit of measure &1 ?

  The SAP error message /CWM/MD023 First reset the category of the parallel unit of measure &1 typically occurs in the context of the SAP Advanced Planning and Optimization (APO) module, particularly when dealing with master data related to units of measure.
  Cause:
  This error message indicates that there is an issue with the configuration of the parallel unit of measure for a material. Specifically, it suggests that the category of the parallel unit of measure needs to be reset before proceeding with the operation you are attempting. This can happen due to:
  
  Incorrect Configuration: The parallel unit of measure may have been incorrectly set up in the material master data.
  Data Inconsistency: There may be inconsistencies in the data related to the units of measure, such as conflicting settings or missing information.
  System Constraints: The system may have constraints that prevent changes to the unit of measure until certain conditions are met.
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Material Master Data:
  
  Go to the material master data for the affected material.
  Navigate to the units of measure section and check the settings for the parallel unit of measure.
  
  
  
  Reset the Category:
  
  If the error message indicates that you need to reset the category, you may need to change the category of the parallel unit of measure to a valid state.
  This can typically be done in the material master data maintenance transaction (e.g., MM02).
  
  
  
  Review Configuration:
  
  Ensure that the configuration for units of measure is correct in the system settings. This may involve checking the configuration in the customizing settings (transaction SPRO).
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to units of measure and the specific error message for additional guidance.
  
  
  
  Testing:
  
  After making the necessary changes, test the process again to see if the error persists.
  
  
  
  Seek Help from SAP Support:
  
  If the issue cannot be resolved through the above steps, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: You may use transaction codes like MM02 (Change Material) or MM03 (Display Material) to access material master data.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Documentation: Review the SAP Help Portal for detailed information on units of measure and their configuration.
  
  By following these steps, you should be able to identify and resolve the issue related to the error message /CWM/MD023.