Message type: E = Error
Message class: CM_EHPRC_BO_WL_CMN - Compliance Worklist - Common Messages
Message number: 119
Message text: Cannot finish worklist generation (compare result key is &1 )
The processing of a worklist generation has been started but could not
be finished.
The system continues with the next available compare result.
INCLUDE NA_SYSADMIN1 OBJECT DOKU ID TX
Check the application log (EHPRC_CP_CORE, WORKLIST) or transaction ST22
to see why the worklist generation report with compare result (key &V1&)
cannot be processed and why the worklist generation fails.
In addition, you can try to run the report
<DS:RE.R_EHPRC_WL_REGCHG_GENERATE>R_EHPRC_WL_REGCHG_GENERATE</> with
the compare result key manually.
Error message extract from SAP system. Copyright SAP SE.
The error message CM_EHPRC_BO_WL_CMN119 in SAP indicates that the worklist generation process cannot be completed due to a comparison result key issue. Here is some related information, along with the cause and possible solution for this error:
Cause: This error occurs when there is an inconsistency or mismatch in the comparison result key during the worklist generation process. The comparison result key is a unique identifier used to compare and determine the differences between objects.
Solution: To resolve this error, you can follow these steps:
Check the comparison result key:
- Go to transaction code CMWB (Change Management Workbench).
- Enter the relevant project and select the "Worklist Generation" tab.
- Check the comparison result key mentioned in the error message (&1).
Analyze the comparison result:
- Use the comparison result key to analyze the comparison result.
- Check if there are any inconsistencies or issues in the objects being compared.
Correct the inconsistencies:
- If you find any inconsistencies or issues, correct them accordingly.
- Make sure the objects being compared are in a consistent state.
Retry worklist generation:
- Once the inconsistencies are resolved, retry the worklist generation process.
- Ensure that the comparison result key is correctly entered.
Contact SAP Support:
- If the issue persists or you are unable to resolve it, contact SAP Support for further assistance.
- Provide them with the error message and any relevant details for a more accurate analysis.
It is important to note that the specific steps to resolve this error may vary depending on your SAP system version and configuration. Therefore, it is recommended to consult your system administrator or SAP consultant for guidance tailored to your specific environment.
Sign up takes 1 minute. 7-day free trial.
CM_EHPRC_BO_WL_CMN118 No check assigned to regulatory list &1; contact your administrator
What causes this issue? For regulatory list &V1& no check is defined.Sy...
CM_EHPRC_BO_WL_CMN117 External specification &1 does not belong to a supplier part
Self-Explanatory Message Since SAP believes that this specific error message is ...
CM_EHPRC_BO_WL_CMN120 Lock failed while processing changes of regulatory list
What causes this issue? After saving a regulatory list the following steps are ...
CM_EHPRC_COD_COMMON001 Substance &1 already assigned; select another substance
What causes this issue? You want to assign substance &V1& to compliance...
SAP messages fall into 3 different categories: Error messages
(message type = E), Warnings (W) or Informational (I) messages.
An error message will prevent you from continuing your work - it is a hard stop and you need to fix the error before you can proceed. A warning message will stop your work, however, you can then bypass the warning by pressing the Enter key on your keyboard. That said, it is still good practice to investigate the cause of the warning message and address it. An information message will not stop your work and is truly just for informational purposes.
Click on this link to search all SAP messages.