/ACCGO/CMN128 - Only basis component can be lifted in term &1 in item &2

SAP Error Message - Details

• Message type: E = Error

• Message class: /ACCGO/CMN -

• Message number: 128

• Message text: Only basis component can be lifted in term &1 in item &2

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

AnswerBot

• What is the cause and solution for SAP error message /ACCGO/CMN128 - Only basis component can be lifted in term &1 in item &2 ?

  The SAP error message /ACCGO/CMN128 Only basis component can be lifted in term &1 in item &2 typically occurs in the context of the SAP Convergent Charging (SAP CC) or SAP Convergent Invoicing (SAP CI) modules. This error indicates that there is an issue with the way components are being handled in a specific term or item.
  Cause:
  
  
  Component Type: The error suggests that the system is trying to lift (or activate) a component that is not classified as a "basis component" in the specified term. In SAP, basis components are typically the fundamental components that can be activated or billed, while other components may depend on them or be supplementary.
  
  
  Configuration Issues: There may be a configuration issue in the product or service definition where the components are not correctly set up to allow for lifting.
  
  
  Item Type: The item in question may not be configured to allow for the lifting of non-basis components.
  
  
  Solution:
  
  
  Check Component Configuration: Review the configuration of the components associated with the term and item. Ensure that the components you are trying to lift are indeed classified as basis components.
  
  
  Review Product/Service Definitions: Go to the product or service definitions in SAP and verify that the components are correctly defined. Ensure that the hierarchy and dependencies are set up properly.
  
  
  Adjust Item Settings: If the item is not meant to allow for the lifting of non-basis components, you may need to adjust the settings or the way the item is structured.
  
  
  Consult Documentation: Refer to the SAP documentation for Convergent Charging or Invoicing to understand the specific requirements for lifting components and the definitions of basis versus non-basis components.
  
  
  Contact SAP Support: If the issue persists after checking the configurations, it may be beneficial to contact SAP support for further assistance, especially if this is a production issue.
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional context.
  Transaction Codes: Familiarize yourself with transaction codes related to product and service configuration in SAP CC/CI, such as /ACCGO/PROD for product management.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.