CTS_CONFIG_MSG_CL161 - System &1 is of type '&2' and 'Extended Transport Control' is active

SAP Error Message - Details

• Message type: E = Error

• Message class: CTS_CONFIG_MSG_CL - Message Class for Central CTS Configuration

• Message number: 161

• Message text: System &1 is of type '&2' and 'Extended Transport Control' is active

What causes this issue?

You want to add a non-ABAP system where 'Extended Transport Control' is
active to a target cluster.

System Response

This scenario is not supported.

How to fix this error?

If you do not need the system in the cluster, delete it from the
cluster.
If you need the system in the cluster, deactivate 'Extended Transport
Control' for system &v1&. To do this, proceed as follows:
1. Call transaction STMS in the communication system of system &v1&.
2. Choose "System Overview".
3. Select the required system by double-clicking on it.
4. On the "Transport Tool" tab page, switch to change mode.
5. As required, set the value of the TMS parameter "CTC" to "0" or
delete it.
6. Confirm the settings and distribute the TMS configuration.

Error message extract from SAP system. Copyright SAP SE.

AnswerBot

• What is the cause and solution for SAP error message CTS_CONFIG_MSG_CL161 - System &1 is of type '&2' and 'Extended Transport Control' is active ?

  The SAP error message CTS_CONFIG_MSG_CL161 indicates that there is a configuration issue related to the Change and Transport System (CTS) in your SAP environment. Specifically, it states that the system is of a certain type (indicated by &2) and that the 'Extended Transport Control' is active. This typically occurs when there is a mismatch in the transport configuration settings.
  Cause:
  
  System Type Mismatch: The system type (e.g., Development, Quality Assurance, Production) may not be compatible with the settings for Extended Transport Control.
  Configuration Issues: The transport routes or the transport layer may not be correctly configured for the system type.
  Transport Layer Settings: The transport layer settings may not be aligned with the requirements of the Extended Transport Control.
  
  Solution:
  
  Check System Type: Verify the system type in the SAP system settings. Ensure that it is correctly defined as Development, Quality Assurance, or Production.
  Review Transport Configuration:
  
  Go to transaction STMS (Transport Management System).
  Check the transport routes and ensure that they are correctly set up for the system type.
  Ensure that the transport layer is correctly configured for the system.
  
  
  Adjust Extended Transport Control Settings:
  
  If Extended Transport Control is not needed, consider disabling it for the system.
  If it is needed, ensure that all systems in the transport route are compatible with Extended Transport Control.
  
  
  Consult Documentation: Refer to SAP documentation or notes related to CTS and Extended Transport Control for specific configuration steps and best practices.
  Transport Layer Configuration: If necessary, adjust the transport layer settings in transaction SE03 (Transport Organizer Tools) to ensure compatibility.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error message or provide additional guidance on configuring Extended Transport Control.
  SAP Community: Engage with the SAP Community forums for insights from other users who may have encountered similar issues.
  SAP Help Portal: Utilize the SAP Help Portal for detailed documentation on Change and Transport System configuration.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP Basis team or reach out to SAP support for further assistance.