Message type: E = Error
Message class: G3 - Messages for SAP Consolidation: Integration
Message number: 684
Message text: Zielposition &1 zu Konto/Kostenart &2 existiert nicht im PosPlan &3
For a general ledger account or a cost element, the corresponding FS
item in the Consolidation chart of accounts is defined as follows:
General ledger account or primary cost element
If a group chart of acounts is assigned to the chart of accounts
belonging to it, the defined group account is taken as the target item.
If no group chart of acounts is assigned to the chart of accounts
belonging to it, the system chooses the general ledger account or the
primary cost element as the target item.
Secondary cost element
If a target item is defined in the Customizing of Consolidation for the
secondary cost element, then this is taken.
Otherwise the system uses the secondary cost element itself, as the
target item.
In the present case target item &V1& is not created for initial account
or initial cost element &V2& in consolidation chart of accounts &V3&.
Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.
Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE
Sign up takes 1 minute. 7-day free trial.
G3683 Zu Konto/Kostenart &1 kann keine Zielposition bestimmt werden
Was verursacht dieses Problem? For a general ledger account or a cost element...
G3682 Es wurden keine Abstimmungsdifferenzen gefunden
Selbsterklärende Nachricht Da SAP der Meinung ist, dass diese spezielle Fehlerm...
G3685 KonsEinheit zu &1 = &2 und int. KonsArt &3 existiert nicht in Sicht &4
Was verursacht dieses Problem? For the operational organizational units &...
G3686 Schlüssel d. 2.Währung f. OrgEinheit &1 in Ledger &2 ist nicht definiert
Was verursacht dieses Problem? Senderledger &V2& conducts values in t...
SAP-Meldungen fallen in 3 verschiedene Kategorien:
Fehlermeldungen (Meldungstyp = E), Warnungen (W) oder
Informationsmeldungen (I).
Eine Fehlermeldung hindert Sie daran, Ihre Arbeit fortzusetzen – es ist ein harter Stopp und Sie müssen den Fehler beheben, bevor Sie fortfahren können. Eine Warnmeldung stoppt Ihre Arbeit, Sie können die Warnung jedoch umgehen, indem Sie die Eingabetaste auf Ihrer Tastatur drücken. Dennoch ist es empfehlenswert, die Ursache der Warnmeldung zu untersuchen und zu beheben. Eine Informationsnachricht wird Ihre Arbeit nicht stoppen und dient wirklich nur zu Informationszwecken.
Klicken Sie auf diesen Link, um alle SAP-Meldungen durchsuchen.